2wheeledprivilege
Junior Member
Posts: 64
Likes: 44
Registered: Jun 2, 2023 16:42:54 GMT -7
|
Post by 2wheeledprivilege on Jun 7, 2024 17:19:47 GMT -7
My 23' Raven black MT-10. Purchased new 6/1/23. Being it's birthday I decided to buy it some gifts. Pulled ECU and sent to 2 wheel dyno works on mon, it came back today. While the ECU was away I installed the Leo Vince' midpipe I purchased back in April. Also a screen protector for the display, some anodized valve stem caps and ordered a set of ASV shorty levers.
Add the most recent mods to the already installed TST tail tidy and integrated taillight, Yamaha comfort seat, bar end mirrors and the factory belly pan from the SP model, the bike and I are in a happy place.
I've only ridden a few miles since the reflash but I must say, the tune from 2WDW is awesome! Bike is smoother, shifts and throttle response, obviously a bit louder. I haven't taken it to redline yet but the power delivery is there from much lower revs than before. Used to be there was a noticeable "hit" at 6k RPM, now the power just builds and builds. If the rain down here would stop for awhile, I could get a "proper" ride in.
I will report back if there are any issues with the reflash, although I don't expect there will be.
Ride safe my Crossplane brothers.
|
|
northsouth
Full Member
Posts: 242
Likes: 108
Registered: Oct 4, 2016 17:58:02 GMT -7
|
Post by northsouth on Jun 8, 2024 15:14:37 GMT -7
Pictures!! Been considering that belly pan. Would love to see it.
|
|
2wheeledprivilege
Junior Member
Posts: 64
Likes: 44
Registered: Jun 2, 2023 16:42:54 GMT -7
|
Post by 2wheeledprivilege on Jun 8, 2024 16:04:15 GMT -7
Ive been meaning to get some pictures posted on here but I dont actually have any. The belly pan was (rather) pricey but I think it looks better than any of the aftermarket options. I acquired the belly pan through Yamaha were I'm employeed but it still cost about double the aftermarket options, not to mention the 2 month wait. The best parts about the factory pan are the fitment and the quick release fasteners for the side pieces, makes service(s) very easy. You can search for some pics of the SP to get a good look at it. It shrouds around the oil cooler at the front, all unpainted plastic matte type finish. Stainless brackets and bolts for mounting and the side pieces are finished in gloss black. Does NOT come with instructions and isn't sold as a kit. I had to pull up the parts diagram on partzilla and use part numbers to get it all on correctly.
|
|
