mesarec
New Member
Posts: 6
Registered: Feb 26, 2021 20:18:17 GMT -7
|
Post by mesarec on Jun 12, 2022 16:16:33 GMT -7
Just put on an akrapovic link pipe. I'm getting a slight leak from where it slips onto the headers. I don't want to crank down too much but not sure if I should.
Any advice, on either how to fix or what to do.
I knew it was too easy to install. Lol.
|
|
|
|
Post by mt10orc on Jun 12, 2022 17:36:12 GMT -7
Just put on an akrapovic link pipe. I'm getting a slight leak from where it slips onto the headers. I don't want to crank down too much but not sure if I should. Any advice, on either how to fix or what to do. I knew it was too easy to install. Lol. So slight leakage may occur when first installed. Give it 50-75 miles for it to break in. If you still have a slight leak tighten a bit and see if it goes away. I have a LeoVince mid pipe and slip on and the directions mention this may occur. There really isn’t any torque settings for connection. Get it tight but don’t jack it up. Someone else may have some advice as well. |
|
