cbrus
New Member
Posts: 1
Registered: Aug 10, 2018 1:47:29 GMT -7
|
Post by cbrus on Aug 10, 2018 2:12:45 GMT -7
Hi!
Had some bad fuel in the engine after it sitting for a while, bike wouldn't turn over. Drained bad fuel, refilled with good. Spent a couple of hours starting the bike to get the bad fuel out, bike finally turns over but only runs on one cylinder and throttle not working. Engine light is on. So bike is in limp mode. Any ideas how to reset? Or do I need to take it to someone with a diagnostic computer?
Thoughts?
|
|
|
Post by RedAndBlack on Aug 10, 2018 7:49:01 GMT -7
New battery if it sat for a while. Judging by how you can only check diagnostic codes with a reader. You probably can't do much of Anything with this bike without a Trip to the dealer.
|
|